This project controls a remote robot through RF. The ordinary 433MHz RF modules are used in this project. 8051 micro-controller is used in this project. It is also an 8051 micro-controller. You can burn the same hex file into any 8051 micro-controller.
You can make the robot to move front and back, turn left and right. Also you can control the speed of the robot from the remote. The PWM technique is used for obtaining the speed control of the motor.
Check "supporting" video at-https://www.youtube.com/watch?v=nKr6tNByRq0
In this project the transmitter part contains a rf transmitting module and uses ASK(amplitude shift keying) modulation to transmit the information to the receiver.
The transmitter side sends the direction info by using an Accelerometer and receiver receives it from the receiver module.
A car is connected to the receiver side whose motors are controlled by the commands sent out by the transmitter, thereby driving the car wirelessly.
You can make the robot to move front and back, turn left and right. Also you can control the speed of the robot from the remote. The PWM technique is used for obtaining the speed control of the motor.
Check "supporting" video at-https://www.youtube.com/watch?v=nKr6tNByRq0
In this project the transmitter part contains a rf transmitting module and uses ASK(amplitude shift keying) modulation to transmit the information to the receiver.
The transmitter side sends the direction info by using an Accelerometer and receiver receives it from the receiver module.
A car is connected to the receiver side whose motors are controlled by the commands sent out by the transmitter, thereby driving the car wirelessly.
No comments:
Post a Comment